Adding Assignments

There are two ways to add assignments to the plan.

1. Draw them directly on to the plan, using the mouse

2. Type the bounding frequencies, and select a polarisation

To draw new assignments this, first click the button at the top of the frequency plan to go into draw mode. Click on the top or bottom of the frequency line depending on the type of polarisation you require. Hold down the mouse button and drag out an assignment block. Release the mouse button to complete the action.

When you have finished drawing assignments, click the button again to exit draw mode.

Below the frequency plan, is the table of frequency assignments. You can type the assignments straight into this table. To add an assignment to the end of the list, click the button. The new assignment will appear in the frequency plan and in the table.

To edit the assignment, simply click in the table and type new values for the lower and upper frequencies. Click in the polarisation cell and a drop down list of polarisation options appears to aid selection.

When you have finished typing in the data, the frequency plan will update to show the new assignment.